Andre Belanger
- Total activity 55
- Last activity
- Member since
- Following 1 user
- Followed by 0 users
- Votes 0
- Subscriptions 25
Articles
Recent activity by Andre Belanger-
Q&A: When the operation of the XT oscillator returns to normal, will it be automatically changed to the XT oscillator?
Full question(s): If the FOS bit is set to 1, it automatically changes to the RC oscillator when the XT oscillator fails. Conversely, when the operation of the XT oscillator returns to normal, wil...
-
Q&A: How do you use TMRPINB as a clock, and what is the clock frequency?
Full question(s): These questions refer to Table 564 of Apollo2 datasheet rev1.0. In the table, TMRPINB is available as a clock source option. TMRPINB is the output signal of timer B, and it seems ...
-
Q&A: If the voltage when the VBAT voltage drops is V_BATRST < VBAT, is the BL bit set correctly?
Full question(s): This question is about when the RTC transits to VBAT Power State (Fig. 29) after VCC power supply is supplied and VBAT is also supplied. Even in the VBAT Power State, if the volta...
-
Q&A: Will FOUT and XT operate normally without VCC being supplied?
Full question(s): In the following scenario, there is a state where only VBAT is supplied without supplying VCC to RTC. 1.) If VCC is not supplied and only VBAT is supplied, will FOUT and XT oper...
-
Q&A: Is there Eclipse IDE support for Apollo1?
Full question(s): AmbiqSuite SDK Getting Started Guide Revision 1.1 on page 15, "9. Eclipse / GCC" has the following description: "Note: The Eclipse/GCC environment is not operational due to an un...
-
Q&A: Does AM0805 register access via the I2C interface still work if the XT oscillator is not mounted?
Full question(s): Is I2C communication possible in a system that does not have the XT oscillator? During I2C access from the host to the RTC, the ACK signal does not respond. The internal timer ...
-
Q&A: Is the I2C input threshold voltage Vt+ and Vt-?
Full question(s): When operating the AMx805 at 2.4 V power supply voltage, what is the threshold voltage of the I2C ports? I assume that the I2C input threshold voltage is Vt+, Vt- described in "T...
-
Q&A: Is the I2C input threshold voltage for the AM08x5 the same as Vt+ and Vt-?
Full question(s): I am using the AM0805 and planning to operate at 2.4 V power supply voltage. I am concerned about the threshold voltage of the I2C ports when operating at VDD= 2.4 V. Is the I2...
-
Q&A: How much current is consumed when RC and XT are both active during AM18x5 auto-calibration?
Full question(s): I am concerned about a possible voltage drop due to sudden current consumption when auto-calibration is executed. In Table 8 of the AM18x5 Datasheet, Ivcc_acal is specified as t...
-
Q&A: What does 0.003 in the bottom view of the "Apollo1 CSP" image refer to?
Full question: This question is about Apollo1's CSP package. A dimension of 0.003 is shown in the BOTTOM VIEW of "Apollo1_CSP" in the Apollo1 datasheet. What is this referring to? Answer: The ...