Apollo3 Blue MCU
- Details for using Apollo 3 without BLE
- Apollo3 Blue PSRAM example code
- Design Guideline: Selecting Proper Inductors for the BLE and SIMO Bucks on Apollo3 MCUs
- Design Guideline: Using an External 32.768 kHz Clock Input on XO on Apollo MCUs
- How to Set up the PDM to Achieve 48/16/44.1 KHz Audio Data
- Q&A: Why do I sometimes see unexpected faults when they should not be happening?
- Q&A: Why is there no STIMER interrupt in some rare cases?
- Q&A: Why do I sometimes see the Ctimer counter keep at 0 after my Ctimer configuration and start operation?
- Q&A: Is there anything special that I need to do when using a 32.768 kHz crystal to clock the Apollo3 B0?
- Apollo3 BLE BUCK Q&A
- Apollo3 SIMOBUCK Q&A
- Q&A: Why am I getting a bus fault error when I run XIP code?
- Apollo3 Blue Patching
- Apollo3 SDK Custom Profile Design
- How to Perform BLE RF-PHY and Telecomm Regulatory Testing on the BLE in Apollo2 Blue and Apollo3 Blue MCUs
- Q&A: Is Apollo3 Blue fully Bluetooth 5 compliant?
- Q&A: What is the supply voltage for Apollo3 for the BLE's specified TX and RX current?
- Q&A: What is the difference between Sleep Mode and Deep Sleep Mode?
- Q&A: Can you set your own operating frequency and power supply voltage for Apollo MCUs?
- Q&A: Is SPOT applied to Apollo3?